An overflowing toilet needs two quick moves. Lift the tank lid and push the flapper down, or turn the supply valve behind the toilet clockwise until it stops. That cuts the water. Then call (860) 397-8103 if it will not clear. We answer 24/7, and same-day appointments are offered when available. Do not keep flushing, which only adds water to a blocked line.
A toilet that overflows once may only need an auger. One that overflows repeatedly can point to a bigger problem in the drain, and a plumber should look at the line.
When a toilet problem is an emergency
Water on the bathroom floor that you cannot stop, sewage backing up from the bowl or other drains gurgling at the same time all warrant an urgent call. If water is dripping through the ceiling below, close the main shutoff. A toilet leak on an upper floor can soak a ceiling in minutes.
If several fixtures back up together, the clog is likely in the main drain, and drain cleaning is the right service.
Repair or replace the toilet
| Problem | Likely cause | Typical fix |
|---|---|---|
| Runs constantly | Worn flapper, fill valve or chain | Replace the flapper or fill valve |
| Weak flush | Clogged rim jets, low water level, partial clog | Clean jets, adjust level, auger the trap |
| Leaks at the base | Failed wax ring or loose closet bolts | Reset the toilet with a new wax ring |
| Rocks on the floor | Uneven floor, loose bolts, damaged flange | Shim, tighten or repair the flange |
| Cracked bowl or tank | Impact, age, freeze damage | Replace the toilet |
| Sweating tank | Humidity and cold water | Add a tank liner or mixing valve |
Toilet overflowing or leaking on the floor? Call the 24/7 line.
Call (860) 397-8103The flange and the floor underneath
A toilet leak at the base is rarely just a wax ring. Water that seeps for months rots the subfloor and corrodes the flange, the ring that holds the toilet to the drain. We check the floor for softness and the flange for cracks before we reset the toilet. A new wax ring on a broken flange leaks again within weeks.
If we find rot, we tell you what we see. Subfloor repair is a carpentry job, but we can mark the area and describe what is needed so you can have it done properly.
Installing a new toilet
A new toilet is a simple swap when the plumbing is sound. We measure the rough-in, the distance from the wall to the center of the drain, so the new toilet fits. We replace the supply line and shutoff valve if they are old, set the toilet on a new seal and check for leaks and rocking.
Water-efficient models are widely available, and a taller bowl can be more comfortable. A toilet that clogs often may be a poor design, not a drain problem, so we can suggest models with strong flush performance.
Older homes and shared drain lines
Older Windsor homes may have toilets on cast iron stacks or on branch lines that run long distances in the basement. Frequent clogs in those homes sometimes come from the drain, not the toilet. A camera inspection shows whether something is stuck in the line, and sewer camera inspection is the next step when a toilet clogs repeatedly.
Basement toilets, often called up-flush or sewage ejector toilets, use a pump. When those fail, water can back up into the pit or the bathroom, and they deserve a prompt visit.
Choosing a replacement toilet
Measure the rough-in, the distance from the wall to the center of the drain bolts. Most are twelve inches, though some are ten or fourteen. Decide on a round or elongated bowl and a standard or taller seat height. Look for a flush that clears waste in a single flush and a glazed trapway that resists clogs.
Dual flush models save water. Pressure-assist models flush forcefully but are louder. A plumber can help you pick one that fits your space and your drain, and set it on a new seal so it does not rock or leak.
Frequently asked questions
Yes. The line is answered 24/7. Call (860) 397-8103 if water is overflowing or leaking and the shutoff does not stop it. Same-day appointments are offered when available.
Remove the tank lid and push the flapper closed, or turn the supply valve behind the toilet clockwise. Then mop up and avoid flushing again until it is cleared.
A worn flapper, a misadjusted chain or a failing fill valve is the usual reason. These parts are cheap to replace, and a running toilet can waste a lot of water.
It can break the wax seal and cause a slow leak that damages the floor. Tightening bolts or shimming may fix it. If it keeps rocking, the flange may be damaged.
Sometimes. It depends on the drain, vent and floor structure. We assess the plumbing before we quote a move.
Yes. We serve all of Windsor and nearby towns, including the ZIP codes 06095 and 06006.
Need a plumber for this right now? The line is answered around the clock.
Call (860) 397-8103