A boiler that stops in the cold can freeze pipes in hours. If the house is losing heat, open cabinet doors on exterior walls, let a thin trickle of water run at the farthest tap and keep one warm room closed up. Then call (860) 397-8103. We answer 24/7, and we offer same-day appointments when available.
We repair hot-water boilers and the plumbing around them. Gas or oil burner tuning belongs to heating specialists, and we say so when that is the real issue.
When a boiler failure is an emergency
No heat in freezing weather, water leaking from the boiler or piping, a smell of fuel or a boiler that shuts down repeatedly all deserve a prompt call. If you smell gas, leave the house and call the gas utility or 911. If you suspect carbon monoxide, get fresh air first.
Heating oil leaks are also serious. Do not try to clean them up yourself. Call the right authorities and your fuel supplier.
Common boiler problems
| Symptom | Likely cause | What we do |
|---|---|---|
| No heat, boiler off | Failed thermostat, safety control or power | Test controls and restore operation |
| Boiler runs, radiators cold | Air in the system, failed circulator, closed valve | Bleed air, replace circulator, check zones |
| Pressure too high or low | Failed expansion tank or fill valve | Replace the tank or valve and set pressure |
| Leaking at the boiler | Failed relief valve, cracked section, loose fitting | Isolate and repair or replace |
| Banging or kettling | Scale, low water flow or air | Flush, clean and correct flow |
No heat? Call the 24/7 line and keep the pipes warm.
Call (860) 397-8103Hydronic systems in older Windsor homes
Hot-water baseboard and radiator systems are common in older New England housing, including homes near Windsor Center, Poquonock and Wilson. These systems use zone valves or circulators to move heated water through the house. The most frequent failures are circulators, zone valves, expansion tanks and air in the lines.
Boilers last a long time when maintained. An annual service helps catch small problems before the first cold snap. If you hear gurgling, see rust at fittings or notice uneven heat, schedule a visit before winter, not during it.
Pressure, expansion tanks and relief valves
A hot-water boiler runs under pressure, and the expansion tank gives heated water room to expand. When the tank loses its air charge, pressure spikes and the relief valve may discharge. We check the tank and the fill valve, set the right pressure and test the relief valve.
A dripping relief valve is a symptom, not a nuisance. Never cap it. The valve is protecting the system from overpressure.
Boiler or water heater problem?
Some homes use the boiler to heat domestic hot water as well. If your showers go cold at the same time as the radiators, the boiler is the likely source. If only the taps are cold, the problem may be an indirect tank or a separate unit, and water heater repair applies.
When a boiler is at the end of its life, we explain replacement choices and the plumbing changes that come with them, which we can handle alongside the heating contractor.
Getting ready for the heating season
Before the first cold week, check the boiler for leaks and rust, confirm the pressure on the gauge sits in the range marked for your system and bleed any radiators that stay cold at the top. Make sure the expansion tank has air and that the zone valves open and close.
Keep the area around the boiler clear. Know where the emergency switch and the shutoff valves are. Having a plumber check the system on a mild day costs less in stress than a call on the coldest night of the year.
What to do when a boiler problem is a safety problem
If you smell gas, or a carbon monoxide alarm sounds, leave the building at once and call 911 from outside. Do not turn lights on or off, and do not try to relight a pilot. Call the gas utility from a safe place. Boiler trouble with no gas smell and no alarm can wait for a plumber, but a hissing sound, a water leak near the burner or a tripped breaker should be treated carefully.
Do not open a boiler's pressure relief valve to test it unless you know how, and do not run a boiler that is leaking or making unusual noise. Shut the unit off, close its water feed if you can reach it safely and call. Heat can be restored. A cracked heat exchanger or a flooded burner room cannot be rushed.
Code reference for boiler work
Boiler work involves gas piping, venting and water connections. Connecticut's State Building Code uses the International Plumbing Code (IPC) as its plumbing standard. The 2022 state code adopts the 2021 IPC, and the state is working on a newer edition. Ask the Windsor building department which permits apply. Source: Connecticut Office of the State Building Inspector.
Frequently asked questions
Yes. The line is answered 24/7. Call (860) 397-8103 for no-heat failures, leaks and pressure problems. Same-day appointments are offered when available.
Open cabinet doors on exterior walls, let a thin stream of water run at the farthest faucet and close off the coldest rooms. If a pipe freezes, shut off the main and call.
A failed expansion tank or an overfilled system are common causes. We check both and reset the pressure.
Air in the system usually. Bleeding the radiators or purging the zone often restores heat.
We handle the water side and plumbing of the boiler. Burner tuning and combustion work should go to a heating specialist, and we will say so if that is the issue.
Yes. We dispatch to those towns, and you can read about Bloomfield and East Hartford.
Need a plumber for this right now? The line is answered around the clock.
Call (860) 397-8103